Epoxy Flooring in Fort Lauderdale, FL

Epoxy flooring in Fort Lauderdale starts with one question we ask before anything else: how wet is the slab underneath? The city has about 165 miles of waterways inside its limits, sits at an elevation of roughly 7 feet, and averages close to 61 inches of rain a year. Concrete on a canal-front lot or a low interior street can hold more moisture than it looks like it does, and moisture pushing up from below is the most common reason a garage coating peels. We test first, then pick the system.

Why the slab test matters here

South Florida sits on the Biscayne Aquifer, a shallow layer of highly permeable limestone whose top is the water table itself. In plain terms, groundwater is never far from the bottom of your garage slab. If a slab was poured without a good vapor barrier, water vapor moves up through it, especially in the wet season from May through October. A coating that cannot handle that vapor drive can blister within a season. We measure moisture before quoting and, when readings call for it, include a moisture-mitigating primer in the written scope instead of hoping for the best.

After April 2023

Many owners here remember April 12 and 13, 2023, when 25.91 inches of rain fell at the Fort Lauderdale airport in a single day, the most ever recorded in the city. Some homes took in water, and garages, sitting lowest on the lot, often got it first. If your garage floor flooded and the old paint or coating is now lifting in sheets, it needs to come off completely. We grind the slab back to sound concrete, let it dry, test again and only then coat. A flake or solid-color epoxy floor will not stop a flood, but a non-porous surface is far easier to hose out and dry than bare concrete or a peeling paint job.

Systems we install in Fort Lauderdale

• Garage floor epoxy with a moisture-tolerant primer where readings require it
• Epoxy flake floors that hide sand, salt and tire tracks and add grip when wet
• Polyaspartic topcoats that hold up to sunlight at an open garage door and can be walked on quickly
• Metallic epoxy for interior rooms, storefronts and finished garages
• Patio and pool deck coatings for screened lanais and dock-side walkways
• Commercial and warehouse floors for marine shops, storage bays and service areas

Sun and salt on outdoor surfaces

Fort Lauderdale gets around 3,000 hours of sunshine a year and sits on 7 miles of Atlantic beach. Plain epoxy is not built for direct sun; it yellows and chalks. For pool decks, walkways and patios we use UV-stable coatings and textured finishes chosen to be less slick underfoot when wet. Near the beach, salt spray settles on everything, so outdoor floors should be easy to rinse, and we leave expansion joints and drainage paths open so water does not sit.

Owners and renters

About 54% of homes in the city are owner-occupied, so a good share of the floors we look at belong to landlords, condo units with private garages and short-term rentals. For a rental, we usually steer toward a flake system with a polyaspartic topcoat: it hides wear between tenants and recoats well later. For an owner planning to stay, a thicker build and a metallic or custom flake blend may make more sense.

Getting a quote

Call (954) 738-6482 or send photos and rough measurements. We visit, run a moisture test, look at cracks and old coatings, and give you a written quote that lists prep, primer, base coat and topcoat. Typical residential garage systems in Broward fall in a broad per-square-foot range depending on prep and finish; your written quote is the number that counts.

Get a Free Estimate